Table of Contents
Advertisement
18
www.aeg.com
CAUTION!
Do not use abrasive
materials or steel wool to
clean the drum.
10.5 Cleaning the control
panel and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
11. TROUBLESHOOTING
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The
On/Off button was not
pushed.
The
Start/Pause button was
not touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Dryness option was set to
4)
iron dry .
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
CAUTION!
Do not use furniture
cleaning agents or cleaning
agents which can cause
corrosion to clean the
appliance.
10.6 Cleaning the airflow slots
Use a vacuum cleaner to remove fluff
from the airflow slots.
Connect to the mains socket.
Check fuse in fuse box (domestic
installation).
Close the door.
Push the
On/Off button.
Touch the
Push the
On/Off button.
Select a suitable program.
Clean the filter.
Change
Dryness option to
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Remedy
Start/Pause button.
2)
3)
5)
3)
Advertisement
Table of Contents
