Installation - MTX Can-Am Maverick X3-17-DK Owner's Manual

INSTALLATION

Step 1 - Remove the cover from top center of the dash.
Step 2 - Locate the four (4) dimples formed into the tray area on the top center dash. Two are located
toward the front and two are at the rear under the cover that was just removed. Using a ⁄ " drill bit,
1
8
drill through the dimples just enough to expose the existing boss located below. Caution: Drilling
deeper can damage the bosses beneath and prevent proper installation of the dash kit.
4
M T X . C O M