Advertisement
If routing your tablet cable atop the
#5
mounting surface, feed it through
the Mounting Arm as shown.
Fixing From Below:
B1
Screw in the 4x Socket Set Screws.
Ensure full thread engagment.
4x Tablet Supports
1x Cable Clip
Install the Tablet Setup Kit. Each kit is specific per
#7
tablet device and Bouncepad Case.
Fixing From Above:
A1
Lift & hold the rubber screw covers.
Use caution to not scratch the parts.
Metal Washer
Nyloc Nut
Metal Washer
Wing Nut
Secure to the surface. Nylocs provide
B2
higher security whilst Wing Nuts
allow for easier removal.
4x Corner Pieces
Route your tablet cable through
#8
the Case. Install the tablet into
the Case and connect to power.
*Must be completed by hand.
Take care to ensure the screws go in
fully and are straight.
Take care to not damage any parts.
Fixing From Above:
A2
Secure the base with the 4x screws.
Close the screw covers once finished.
*if routing your cable atop the
mounting surface, feed this
T20 Driverbit
M4 Button head screw
Case Washer
Installation of the mounting arm is
#6
complete. Now install your Case as
shown above.
Locate and lock the Faceplate
#9
to the Case.
through the Case now.
M4 Split Washer
Advertisement
