bouncepad Swivel Desk Assembly Instructions

Swivel Desk/S60
Assembly Instructions
Follow these instructions for
the successful assembly your
Bouncepad Swivel Desk/S60.
Sheet Code: BP-OR-IM-022_REV2
Release Date: 24/07/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Configure the angle of rotation - ensuring both
arrows are pointing in the same direction before
#1
starting. Default angle configuration is 270˚.
Insert the limit screws for 90˚ or 180˚ rotation.
Using the template (see A4) mark and drill the
#3
mounting holes appropriate to your mounting
surface and cable routing configuration.
Faceplate
Static60
Mounting
Arm
or
Desk
Mounting
Arm
0
In the box
#2
3.5mm Drillbit
A
*if fixing from above
4mm Drillbit
B
*if fixing from below
Holesaw
C
*if routing the tablet
cable through your
mounting surface
#4
Case
Fixings Kit
Tablet Set-up Kit
Rotate
*Desk *S60
Attach your chosen mounting arm. Your mounting arm must forward lean
in the same direction as the two arrows. Tighten by hand, ensuring full
and correct engagement.
B
A
B
20mm
Use the above template to mark the drill holes - appropriate to your
chosen fixing method. 'A' if fixing from above. 'B' if fixing from below.
Follow the corresponding steps (PTO) specific to each fixing method.
7mm Spanner (or
4.0mm Drillbit
adjustable Spanner)
*if fixing from below
3.5mm Drillbit
*if fixing from above
Socket
Pencil
Screwdriver
0
Tools Required
A
C
Front
A
Ø65.5mm
20mm
Holesaw
*if routing the tablet
cable through your
mounting surface
Electric Drill
T20 Driverbit
Buttonhead
screw
Ø68.0mm
B
A
B