Coleman SMOKE GENERATOR Manual

Coleman SMOKE GENERATOR Manual

Smoke generator

Advertisement

FOR BEST RESULTS FOLLOW THESE STEPS

LOADING

Fill the smoke generator with pellets
TIP:
Don't overfill the generator. If the pellets are piled above the dividers, the burn can jump rows, which will
reduce the length of smoke time.

LIGHTING

Place the smoke generator on a flat surface or resting flat on your grill.
Use a propane torch to light the pellets through the starter hole.
Hold the torch to the pellets for a long enough time to properly ignite them (around 45 seconds).
Let the flame burn for 5-10 minutes.
TIP:
If you don't have a propane torch, you can add gel alcohol to the pellets near the starter hole and ignite it
with a BBQ lighter.
085-2343-0/ FS-6145C
Coleman Smoke Generator Draft 2 EN_colored.indd 1
Coleman Smoke Generator Draft 2 EN_colored.indd 1
SMOKE GENERATOR
X
www.colemanbbqs.com
Last Updated: 2020-09-30 WZ
2020-10-01 2:20 PM
2020-10-01 2:20 PM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMOKE GENERATOR and is the answer not in the manual?

Questions and answers

Summary of Contents for Coleman SMOKE GENERATOR

  • Page 1 LIGHTING Place the smoke generator on a flat surface or resting flat on your grill. Use a propane torch to light the pellets through the starter hole. Hold the torch to the pellets for a long enough time to properly ignite them (around 45 seconds).
  • Page 2 Close the grill lid. TIPS: Don’t handle the smoke generator while it’s in use. If you must, use protective heat resistant gloves. Smoke times range from 4-8 hours, but can vary depending on type of pellets, amount of dust used, wind, venting, and ambient temperatures within your BBQ/Smoker.

This manual is also suitable for:

85-2343-0

Table of Contents