Page 1
User Manual T-BBQ 3100 G BK-SS EN ES PT FR teka.com...
Page 2
GAS BARBECUE Should you have any questions, please contact us. Contact information can be found on our website teka.com. MANUAL MUST BE READ BEFORE OPERATING!
Table of contents Before you start using the appliance ............................5 Intended use ....................................5 Safety precautions ..................................5 Safety symbols .................................... 5 Safety Instructions ..................................6 Battery Safety Information ................................. 7 Scope of supply ..................................... 8 Assembly......................................8 Preparation ....................................8 Required tools .....................................
Before you start using the appliance materials during use. – Do not move the appliance during use! After unpacking the appliance and before each use, check it – Turn off the gas supply at the gas cylinder after use. for any damage. –...
assembly. Danger! Risk of fire! 4. Always turn the gas supply off on the gas cylinder or the Never attempt to switch on/light the barbecue pressure regulator and disconnect the gas hose after use. with the lid closed. 5. Never store gas cylinders indoors or close to heat sources. - Only operate the gas barbecue with the lid closed at a low 6.
Battery Safety Information Danger! Risk of injury! Both the barbecue and individual parts have some 1. WARNING: KEEP BATTERY OUT OF REACH OF sharp edges. CHILDREN. Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can - Individual parts of the barbecue must be handled with care occur within two hours of ingestion.
Scope of supply Assembly Preparation 1x warming rack 2x grill grates (B2) with grate insert (B3) Before beginning assembly of product, make sure all parts 3x heat distribution plates are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do 1x burner housing not attempt to assemble the product.
Page 9
Step 1 Step 2 Fasten the door lock (Q) to the base plate (R) with screws Screw the gas cylinder holder (S) to the base plate (R) with screws , snap ring and nuts Step 3 Step 4 Fasten the rear cross beam (A1) to the rear support legs (X, I) Use the screw and snap ring to fasten the front right...
Page 10
Step 5 Step 6 Fasten the top door rail (H) to the front support legs (W, L) Fasten the top side bars (J) to the support legs with screws with screws Step 7 Step 8 Insert the caster with latch (O) into the front left support leg Loosen the retaining screws on the support legs (see detailed (L).
Page 11
Step 9 Step 10 Fasten the door handle (P) to the door (Y) with screws Tighten the casters (O, N) with an open-end wrench. Secure the wheels (U) with a split pin and put on the hubcaps (T). Step 11 Step 12 1.
Page 12
Step 13 Step 14 Secure the side burner support angles (B1, C1) underneath Fasten the burner housing (D) to the support legs with screws the side burner housing (D1) with screws Step 15 Step 16 Loosen the retaining screws on the left side of the burner Secure the left side shelf support angles (F, G) underneath housing (D) (see detailed drawing) and mount the side burner the left side shelf (E) with screws (B).
Page 13
Step 17 Step 18 Fasten the side burner housing (D1) to the burner housing (D) Loosen the retaining screws on the right side of the burner from the inside with screws and washers . Tighten the housing (D) (see detailed drawing) and mount the left side retaining screws.
Page 14
Step 21 Step 22 Guide the side burner hose through the hole in the side Insert the side burner (H1) into the side burner housing (D1) burner support angle (B1). Remove the nut from the venturi from above. Align the venturi on the valve. Ensure that the and attach it to the bracket.
Page 15
Step 25 Step 26 Put the heat distribution plates (C), the aroma box (F1) and the aroma box lid (G1) in the burner housing. Place the warming rack (A) and the grill grates (B2, B3) on the burner housing. Step 27 Step 28 Important: Push the drip tray (Z) from behind under the burner housing.
Inserting the battery national conditions require it. Contact your dealer for replacement. The hose must not be twisted or kinked. Make sure that the Make sure to insert a battery into the appliance for automatic gas hose is not obstructed, kinked, or in contact with any parts burner activation.
Operation Always check for leaks using soapy water. Never use an open flame to detect leaks. Danger! Risk of explosion! Checking for gas leaks Read through the following instructions for turning on/firing up the barbecue and all warnings and • Extinguish any open flame or cigarettes in the area. safety instructions before actually firing up the •...
7. The side burner is turned on and operated in the same way barbecue to (off). Wait until the barbecue has cooled down as the main burner. sufficiently before closing the lid. 8. To switch off the barbecue, set the regulator on the gas cylinder to Off.
Maintenance and cleaning Cleaning the ignition head • Soiling of the ignition head tip may make it difficult to build Your barbecue is made of high-quality materials. up fire. In this case, it must be cleaned. The ignition head tip Clean the barbecue after each use.
LPG cylinder is empty Replace with full LPG Specifications cylinder Defective regulator Have the regulator Product: Item no. T-BBQ 3100 G BK-SS Blocked burner checked or replaced gas barbecue Blocked gas nozzles or Cleaning the burners Weight: approx. 33.2 kg...
Need help?
Do you have a question about the T-BBQ 3100 G BK-SS and is the answer not in the manual?
Questions and answers