Advertisement
3. Insert four anchors
4. Install wall plate assembly using four lag bolts
only until they are pulled firmly against the wall plate assembly. but do not over tighten. Over
tightening can damage the screw , reducing it's holding power. (fig 3.4)
3.3
STEP 3: Attach TV Bracket to TV
1.Select TV Screw Diameter
Hand thread screws into the threaded
inserts on the back of your TV to determine
whichscrew diameter ( M5,M6 or M8 ) to
use.
M5
M6
M8
3.Attach the bracket
spacer/screw/washer (Round Back / Extra Space). (fig 4.1)
IMPORTANT: Ensure TV bracket is securely fastened before moving on to the next step.
, Be sure the anchors
29
29
2. Select TV Screw Length
If your TV has a flat back AND you want your TV closer to the
wall, use the shorter screws.
Spacers and longer screws are supplied to accommodate:
● Round/irregular back TVs
● TVs with inset mounting holes
● Extra space needed for cables
FLAT BACK
to the back of the TV using the appropriate screws/washers (Flat Back) or
05
are seated flush with the concrete surface.(fig 3.3)
29
and four washers
27
3.4
28
27
ROUND BACK
INSET HOLES
. Tighten the lag bolts
28
CAUTION:
Verify adequate thread
engagement with your
screw/washer/spacer
combination AND
TV bracket
-Too short will not hold the TV.
-
Too long will damage the TV.
CABLES
Too Short
Correct
Too Long
27
Advertisement
