Levita PW 90+ Operation Manual page 35

Start up
Park the appliance on an even surface.
Insert the mains plug into the socket.
Water supply
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the high-pressure pump and the accessories.
Water supply from mains
Drawing in water from the open reservoirs
This high-pressure cleaner is suited to work with the YILI suction hose with backflow vale to draw in
surface water, e.g. from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water connection of the appliance and insert it into the water source
(e.g. rainwater drum).
Bleed the device as follows prior to operation:
•
Turn on the appliance "OFF/ON"
•
Unlock the lever of the trigger gun.
•
Push the lever of the trigger gun, the device will switch on.
•
Let the device run (max. 2 minutes) until the water exits the trigger gun without bubbles.
•
Release the lever of the trigger gun.
•
Lock the lever of the trigger gun.
Operation
ATTENTION
Dry running of more than 2 minutes leads to damage of the high-pressure pump. If the appliance does
not build up pressure within 2 minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting"
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid damage.
CAUTION Make sure the on/off switch is set to "OFF/O" and insert the plug into a properly
installed socket.
34