Cabletron Systems EMC39-12 User Manual page 13

Chapter 2: Installation
2.2.1 Rack Mounting the EMC39-12
Before installing the EMC39-12, care must be taken to ensure that the
rack used will support the unit and that the rack remains stable with the
EMC39-12 installed. In order to allow for proper cooling within the rack,
there must be a two-inch clearance on either side of the unit. Refer to
Chapter 1, Introduction for power and environmental requirements.
The following procedures explain how to install the EMC39-12 in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the EMC39-12. Figure 2-1 shows the
location of the screws.
Do not remove the cover from the EMC39-12. There are no
user configurable devices inside and the electronics are
static sensitive.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the EMC39-12.
TPLINK
XMT
RCV
PWR FOLNK
Figure 2-1
Page 2-2
Rack Mounting
Brackets (2)
EMC39-12
Ethernet Media Converter
RX TX RX TX RX TX
12 11 10 9 8 7 6 5 4 3 2 1
12 11 10
Screws (4)
Installing the Rackmount Brackets
LANVIEW
WITH
RX TX RX TX RX TX RX TX RX TX RX TX RX TX
9 8 7 6 5 4
RX TX RX TX
3 2 1
EMC39-12 User's Guide