Mobile Home Installation - England's Stove Works 30-NC Installation & Operation Manual

REFER TO CHIMNEY AND CHIMNEY CONNECTOR MANUFACTURER'S INSTRUCTIONS
WARNING: INSTALL VENT AT CLEARANCES SPECIFIED BY THE
2 Ft. higher than
nearest point of roof
within 10 ft.
Single wall flue pipe
assemblies must not
exceed 10 feet in
overall length.
Illustration 5

Mobile Home Installation

Secure the heater to the floor using the two holes in the pedestal. If the unit is on a combustible
surface, you will need to drill matching holes in the floor protection that you choose (see Floor
Protection section). Do not disturb the structural integrity of the home, and be sure the unit is
permanently electrically grounded to the chassis of your home. Remember that outside combustion
air is mandatory, and not to install the unit in a sleeping room of the home.
Outside Air Connection
When installing this model in a mobile home or double wide it is necessary to supply the
combustion air into the unit from outside the dwelling. NOTE: THIS STOVE IS MOBILE HOME AND
DOUBLE WIDE APPROVED (WITH OUTSIDE AIR HOOK-UP) FOR THE PEDESTAL MODEL ONLY
– NOT FOR LEG MODELS.
This can be done by running a thin gauge three inch (3") pipe (flex or rigid) from the air inlet pipe
located on the rear of the stove through the floor or wall (measure pipe to ensure you obtain the
correct size). The outside end of this pipe should be covered in some manner (i.e. screen) to keep it
clear of foreign matter. Be sure to keep it above the snowdrift line and clear of leaves and other
debris. If you are installing this stove in a regular dwelling this connection is not necessary, but is
recommended in air-tight homes.
A kit is available from England's Stove Works, Inc. designed for connecting this unit to outside
combustion air. [Part No. AC-OAK3]
CHIMNEY
VENT MANUFACTURER
3 Ft. min. from
Roof Penetration
Min. overall
height from floor
15 Ft.
15
CONTACT YOUR LOCAL BUILDING AUTHORITY
FOR APPROVED METHODS OF INSTALLATION
1. This appliance requires a masonry or pre-
manufactured chimney listed to UL103HT
sized correctly.
2. If a masonry chimney is used, it is advisable to
have your chimney inspected for cracks, and
check the general condition before installing
your unit. Relining may be required to
reduce the flue diameter to the appropriate
functional size.
3. To help ensure a good draft, the top of the
chimney should be at least 3 feet above the
point of penetration through the roof, and be
at least 2 feet higher than any point of the roof
within 10 feet.
4. The chimney connector shall not pass through
an attic, roof space, closet, concealed space,
floor, ceiling, wall,
combustible construction.
5. The minimum overall height of your chimney
should be 15 feet from the floor.
6. Do not use makeshift compromises during
installation.
or any partition of