Magnum Lighting ML-1000 Owner's Manual And User's Manual page 10

temperature related. Such failures are NOT covered under our manufacturer's
warranty. Extreme cold and hot temperatures WILL cause a diode failure. Keep
this unit climate controlled at ALL times.
10. Always ensure that the main power supply is properly grounded before use.
Do not use a 2 prong IEC cord with this projector. You should always hook up a
laser system in such a way that you have both a primary and backup means of
instantly terminating laser emissions.
11. DO NOT USE the laser device if you suspect that it contains a defect of any
kind either from manufacturing, damage, general wear or has a broken
manufacturer's seal. Contact Magnum Lighting to return the unit to the factory for
service and/or maintenance immediately.
12. Should you have difficulty operating the laser properly and troubleshooting
does not work, go to http://www.magnumlighting.com for support and RMA
assistance if necessary. Do not attempt to service, modify or fix the laser yourself.
You will be provided with instructions on how to send the laser projector back for
repair.
13. Before using this product in any capacity, ensure that the unit is properly
secured to prevent accidental beam shifts and that a safety cable is used for any
aerial rigging.
14. This product is not a toy and should be kept inaccessible to unauthorized
persons before, during, and after use. Keep away from minors.
15. Authorized persons should only be employees of an FDA variance holder.
See the Magnum website: http://variance.magnumlighting.com/ for obtaining a
variance and to view online laser safety and operator training.
16. This product is not to be used outdoors. Do not allow laser light to escape
indoor settings as this level of laser light can interfere with Aircraft operation at
many miles. DO NOT allow lasers to hit aircraft or enter airspace. Shining a laser
at an aircraft in the US is considered a federal crime punishable by fines or jail
time.**
17. Before using this product, it is the responsibility of the user to be familiar with
all Federal and State reporting and usage requirements. Laws vary by state,
some US states require additional licensing and/or registration. Many locations
require operation only under the supervision of a trained Laser Safety Officer
(LSO). An FDA variance is required to operate this product in the United States.