FLUVO WK Operator's Manual

FLUVO WK Operator's Manual

Centrifugal pump

Advertisement

Quick Links

D
Centrifugal pump type WK
Operator's Manual
GB

Advertisement

Table of Contents
loading

Summary of Contents for FLUVO WK

  • Page 1 Centrifugal pump type WK Operator’s Manual...
  • Page 2 Leiter Qualitätssicherung / Directeur d’assurance de la qualité / Manager of quality assurance / Director del assegunamiento de qalidad / Direzione qualità / Tel. +49(0)7071 7008-18 Schmalenberger GmbH + Co. KG Pumpe Typ WK D-72072 Tübingen / Germany Version: 27220 - B...
  • Page 3: Table Of Contents

    Device Units ..................13 Pump Kit Type WK ....................... 13 Assembly..................14 Assembly - General ...................... 14 Assembly of the Control Box (Type WK Only).............. 14 Assembly of WK-Vario....................15 Flow Losses - Pipes and Elements................16 Operating the Centrifugal Pump ............ 17 Initial Start-up........................
  • Page 4: General Information

    Specification with all information Not all the documents named above exist or are included in every case. Observe the information in the specification in this regard. Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 5: Technical Data / Specification

    The confirmation of order together with the delivery slip can be used as a replacement as proof of technical data. See data sheet Data Sheet for the WK Pump Limit values Rated values of motor of the pump...
  • Page 6: Safety Instructions

    There must not be any conducting connection between the metallic components of the motor and a liquid. Safety Instructions for Connection and Commissioning • Electrical equipment must only be installed and serviced by qualified personnel in Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 7: Safety Instructions For Connection And Commissioning

    The suction connection (strong suction effect) • The pressure connection (high discharge speed of objects that may have been sucked • The pump housing (heating) Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 8: Transport, Storage And Assembly

    This preservation must be removed before commissioning; see chapter 3.2.2 Cleaning. If the pump will be taken out of operation for an extended time or if the storage time Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 9: Unpacking, Cleaning And Assembly

    Other external accessories such as air chambers, etc., that are not premounted on the centrifugal pump in the factory should not be connected until after the centrifugal pump is installed in the system or on the pump foundation. Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B...
  • Page 10: Setting Up And Connecting

    For short pipelines, the nominal widths should at least match those of the pump connections. For longer pipelines, determine the most cost-effective nominal width from case to case. Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 11: Electrical Connection

    Danger of explosion! If there is danger of explosion, a motor protection device must be installed! Electrical Connection - Pump Type WK Connect the motor according to the circuit diagram in the terminal box or the "Delta connection" or "Star connection" image.
  • Page 12 For additional information, see the Operator's Manual Pump Control (27122). Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 13: Device Units

    Device Units Pump Kit Type WK The pump kit consists of: 1. Pump unit item 01* 2. Suction hose item 16** 3. Pressure hose item 13** 4. Switching tube ø 4 mm item 31** 5. Control box item 02** 6. Cable protection cover...
  • Page 14: Assembly

    (K). Caution: Do not kink the switching tube and keep it as short as possible; maximum length 8 8132 Fig. 6 Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 15: Assembly Of Wk-Vario

    Assembly of WK-Vario 6.3.1 Combination with Massage Jets Zur hydro-massage > Zur hydro-massage > Zur hydro-massage > Z u r G Luftregler A n s a u g u n g Wasserregler WK Pumpe WKvario Fig. 7 6.3.2 Combination with Water Curtain Rückschlagventil...
  • Page 16: Flow Losses - Pipes And Elements

    Pressure loss Flow speed Abrupt pipeline 2.562 m/s 0.278 bar constriction 80 to 50 mm Edged run-in under 2.562 m/s 0.027 bar angle Fig. 9 Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 17: Operating The Centrifugal Pump

    To avoid large temperature increases in the motor and excessive load on the centrifugal pump, motor and bearings, one switching-on process per minute must not be exceeded. Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 18: Notices Of Incorrect Operation

    If there is danger of freezing and/or for extended periods of standstill, the pump must be emptied and/or protected against being emptied or freezing (auxiliary heating). Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 19: Emptying The Pump

    Then screw the plug screw (11) back in with a new O-ring (07). 8135 Fig. 10 Troubleshooting for Type WK Caution! If faults occur, turn off the centrifugal pump immediately! All repairs and interventions must be done in accordance with accident prevention requirements (UVV) and must be performed by qualified specialists.
  • Page 20: Maintenance / Repair

    9.2.1 Lubrication and Change of Lubricant Pumps of type WK / WKN in standard design have bearings only in the drive motor. The bearings are designed to last for life and have permanent grease lubrication that cannot be relubricated. Faulty bearings must be replaced.
  • Page 21: Disassembly / Dismantling The Pump

    Observing these instructions is a precondition for problem-free operation of the pump and for honouring any warranty claims that may be submitted. Customer Service: Schmalenberger offers a 24-hour service for spare parts delivery! Appendix Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 22: Decommissioning / Placing In Storage / Preservation

    9.2 Maintenance / Inspection must be performed. Before using the pump again, all the points listed in chapter 7.1 Initial Commissioning must be observed. Schmalenberger GmbH + Co. KG Pump type WK Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 23: Disposal

    Schmalenberger GmbH + Co. KG Im Schelmen 9 - 11 Phone: +49 (0) 7071 - 7008-0 D - 72072 Tübingen Fax: +49 (0) 7071 - 7008-10 Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 24: Spare Parts List And Drawing

    DRAWING 11.1 Drawing - Type WK Pump type WK Schmalenberger GmbH + Co. KG D-72072 Tübingen / Germany Version: 27220 - B...
  • Page 25: Type Wk-Vario

    WK-Vario 75.1 61 75.2 19 79 06 07 08 09 10 07 11 96 97 98 83 93 07 11...
  • Page 26: Spare Parts List

    SPARE PARTS LIST 11.3 Spare parts list - type WK Item Order No. Name Pieces Comment 365445 AC motor 1.5 kW, IEC 38, 230 V, 50 Hz 01.1 360966 Three-phase motor 1.5 kW, IEC 38, 400/230 V, 50 Hz 01.2...
  • Page 27 Hex. socket head cap screw M 8x50 55539 Spacing sleeve 24424 V-ring 22213 Clamp gasket 91409 Transmitter type mono complete See Pump Control Operator's Manual BA-27122 Pump type WK Schmalenberger GmbH + Co. KG Version: 27220 - B D-72072 Tübingen / Germany...
  • Page 28 +49 (0)7071 70 08 - 10 Im Schelmen 9 - 11 Internet: www.fluvo.de D-72072 Tübingen / Germany E-mail: info@schmalenberger.de © 2009 Schmalenberger GmbH + Co. KG; All rights reserved Manual is subject to changes Type: Pump WK Version: 27220 - B...

This manual is also suitable for:

Wk-varioWk6013/2-0.75Wkn6013/2-0.75Wk6013/2-1.5Wkn6013/2-1.5Wk6013/2-1.5 ws ... Show all

Table of Contents