Table of Contents
Advertisement
Do not store gasoline for more than 3 months.
STORAGE/TRANSPORT PROCEDURES
Never place any type of storage cover on this generator while it is still hot.
When transporting or storing this generator for extended time:
• Allow generator to fully cool before moving it. A hot engine and exhaust system can burn you and ignite some materials.
• Empty the fuel tank. (See "Emptying the Fuel Tank" in the "Maintenance/Care" section.)
• Turn the fuel valve to the "off" position.
• Disconnect the spark plug.
• Do not obstruct any ventilation openings.
• Do not drop or strike this generator while moving it.
• Store this generator in a cool dry area, free of excessive dust.
Storage Time
Recommended Storage Procedure (which will help prevent difficult starts)
Less than 1 month
No storage procedure required.
1 to 2 months
Fill with fresh gasoline and add gasoline conditioner
2 months to 1 year
Empty the fuel tank. (See "Emptying the Fuel Tank" in the "Maintenance/Care" section.)
1 year or more
Empty the fuel tank. (See "Emptying the Fuel Tank" in the "Maintenance/Care" section.) Disconnect the spark plug.
TROUBLESHOOTING
IMPORTANT: If trouble persists, call our customer help line at
Symptom
Engine will not start.
Engine will not start.
GEN154 2000 Surge Watts/1500 Running Watts Portable Generator
1-866-460-9436
Cause
Engine switch is set to "off."
Fuel valve is turned to "closed."
Choke is set to "Open/Run".
Engine is out of gasoline.
Engine is filled with contaminated and/or old
gasoline.
Spark plug is dirty.
Spark plug boot is cracked.
Spark plug is broken.
Oil is low.
Spark plugs not sparking.
, Monday - Friday, 8 AM - 4 PM Central Time.
Solution
Set engine switch to "on."
Turn fuel valve to "open."
Set the choke to "Closed/Choke"
Add gasoline.
Drain gasoline from the engine and add new
gasoline.
Clean spark plug.
Replace spark plug.
Replace spark plug.
The oil level should be at the bottom of the
threads on the dipstick hole. If it is not, add or
replace oil.
Verify that you have spark. Pull spark plug cap
off spark plug. Take spark plug out using spark
plug wrench. Loosen the four gas tank bolts
using 10mm wrench. Put spark plug back into
boot and hold it onto bare metal. Make sure the
on/off switch is in the ON position. Pull the
starter. You should see a spark.
21
Advertisement
Table of Contents
