Clas Ohlson SET70R Quick Start Manual

Transformer
Article no: 32-3421 • Model: SET70R
Please read the entire instruction manual be-
fore using and save it for future reference.
Description
- Transformer for 12 V halogen bulbs.
Comes with short connection cables (15
cm) without connectors.
- The transformer has a soft-start feature
which gradually increases the current after
it is turned on.
- Built-in thermal sensor which cuts the
power if the transformer overheats.
- An electronic safety circuit turns the
transformer off if the secondary coil short-
circuits, overheats or if the transformer is
used without any load. When the fault has
been rectified the transformer can be used
again.
Safety and Assembly
- The transformer conforms to both 89/336/
EEC Directive regarding electromagnetic
compatibility and 72/23/EEC Low Voltage
Directive.
- Permanent installation should only be
carried out by a qualified electrician.
GREAT BRITAIN For consumer contact, please visit www.clasohlson.
co.uk and click on customer service.
ENGLISH
- For indoor use only.
- The primary cable must be at least 0.75
mm² and the secondary cable between
0.75 mm² and 1.5 mm².
- To prevent high frequency power supply
interference, do not place the transformer
or its cables close to other electrical
cables.
- The transformer should be placed as
close to the halogen lights as possible.
However not closer than 30 cm because
of the heat from the lights.
- Make sure the transformer has adequate
ventilation and the ambient temperature
does not exceed 45°C.
Specifications
Primary voltage:
Secondary voltage:
Power:
Current:
Housing temperature: 85ºC (max)
Ambient temperature: -20ºC to + 40ºC
Overheating protection: Thermal sensor
Primary cable:
Secondary cable:
230 V, 50 Hz
11.6 V~rms
20-70 W
0.30 A
H03VV-F 2 x 0,75 mm²
1-2 cables,
0.3-4.0 m long or
3 cables,
0.3-3.0 m long or
4-6 cables,
0.3-2 m long