ekwb EK-FB R3Gene Installation And Mounting Manual

Installation and mounting manual for EK-FB R3Gene water block:
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box or in manual..
The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the
liquid seal is made using o-rings.
STEP 1: GENERAL INFORMATION Sample photo of ASUS RAMPAGE III GENE PCB design
STEP 2: PREPARING YOUR MOTHERBOARD
1. REMOVING STOCK COOLER. Remove all encircled screws.
cooler assembly screws should be removed. There are 2 screws on the back of
the motherboard and 2 on top of mosfet stock cooler.
3. APPLYING THERMAL COMPOUND
Apply thermal compound: put a small drop of thermal compound on the
Northbridge. For example Céramique™ thermal compound. Follow this link
http://www.arctic-
cooling.com/catalog/product_info.php?cPath=39_&mID=127&language=en
detailed instructions. EKWB recommends non-conductive MX-2, which should
be applied in cross form for best performance (see sample picture).
5. PLACING THERMAL PADS ON MOTHERBOARD. Place thermal pads you cut on PCB as shown on picture bellow.
(PLEASE REMOVE FOIL OF THERMAL PADS PRIOR TO INSTALLATION.)
Apply small amount of thermal grease
here.
All disclosures, notices and warranty conditions are being written on the back of the box.
Northbridge
Southbridge
All stock
2. CLEANING THE PCB.
Carefully detach the original stock cooler after removing all screws
securing it to the board. Wipe off the remains (by using non–abrasive cloth or qtip, as shown
on sample photo) of the original thermal compound until the components and circuit board are
completely clean. EKWB does not recommend using any liquids for removing paste.
4. CUTTING THERMAL PADS.
(60x25x0,5 mm) are enclosed with your water block. (WARNING: DIMENSIONS ON PICTURES
BELLOW ARE SCALED!)
for
Place thermal pads (1mm thick) here and
make sure all mosfet chips are covered.
www.ekwaterblocks.com
Mosfets
CPU socket
One thermal pads (90x15x1 mm) and one thermal pad
Released on 28
for updates.
th
of September, 2010.