Inverto OneNet 5862 Setup Manual

FCC ID: �APR� -BEE
This device complies with Part �� of the FCC rules. Operation is subjected to the following two conditions: (�) this device may not
cause harmful interference, and (�) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
The device for opration in the band ����-���� MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems;
This device complies with Industry Canada' s licence-exempt RSSs. Operation is subject to the following two conditions:
(�) This device may not cause interference; and
(�) This device must accept any interference, including interference that may cause undesired operation of the device.
The distance between user and products should be no less than �� cm.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part �� of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
■
Thank you for choosing the OneNet™ Node
Set-up in � step
Light
Reset
Pins
You need a working OneNet router
TM
to use the OneNet mesh node.
Need help setting up your OneNet TM router?
TM
Please scan this QR code:
Or visit: www.inverto.tv/support
OneNet
TM
MESH WIFI Node
Set-up Guide