Inverto OneNet 5864 Setup Manual

Mesh wifi router

FCC ID: �APR�-M�

This device complies with Part �� of the FCC rules. Operation is subjected to the following two conditions: (�) this device may not

cause harmful interference, and (�) this device must accept any interference received, including interference that may cause

undesired operation. Changes or modiﬁcations not expressly approved by the party responsible for compliance could void your

authority to operate the equipment.

The device for opration in the band ��-�� MHz is only for indoor use to reduce the potential for harmful interference to

co-channel mobile satellite systems;

This device complies with Industry Canada' s licence-exempt RSSs. Operation is subject to the following two conditions:

(�) This device may not cause interference; and

(�) This device must accept any interference, including interference that may cause undesired operation of the device.

The distance between user and products should be no less than �� cm.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part �� of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected.

■

Consult the dealer or an experienced radio/TV technician for help

■

Thank you for choosing OneNet™ Router

Set-up in � steps

OneNet

MESH WIFI Router

Set-up Guide

Table of Contents

Need help?

Do you have a question about the OneNet 5864 and is the answer not in the manual?

Page 1 Thank you for choosing OneNet™ Router FCC ID: �APR�-M� Set-up in � steps This device complies with Part �� of the FCC rules. Operation is subjected to the following two conditions: (�) this device may not cause harmful interference, and (�) this device must accept any interference received, including interference that may cause undesired operation.
Page 2 �. Connect to the power and WAN cables �. Connect to Wi-Fi �. Open the browser or the OneNet Visit onenet.inverto.tv through a browser to complete Use your mobile device or computer to search for setup. and connect to the OneNet-XXXX Wi-Fi network (no password required).

Onenet 5865