Download Print this page

Nature Power 1800 Installation Manual

Solar generator trolley

Hide thumbs Also See for 1800:

Solar Generator 1800 Trolley Installation Guide

Thank you for purchasing Solar Generator 1800 Trolley, With convenient click & go

design, moving Solar Generator 1800 around becomes never so easy.

Please carefully read ALL below instructions during installation.

Caution: Risk of injury

To avoid muscle strain or back injury, use lifting aids and proper lifting techniques when

moving the unit.

A wrench and Phillips screwdriver are needed during installation.

Components List

A. Supporting Stand

B. Trolley Wheel

C. Rail Support 1

D. Rail Support 2

E. Rail Support 3

Install two supporting stands to unit, fasten them with SCREW G.

F. Wheel Washer

G. Screw (round head) for fastening component A

H. Screw (flat head) for fastening component E

I. Hex nut for fastening component C & D

J. Cap nut for fastening component B & F

Install three RAIL SUPPORT (C, D & E) to the back of the unit, fasten

them with NUT I and SCREW H. Make sure to place one piece of

foam underneath before turning unit 90 degrees. All three RAIL

SUPPORT FEET should be installed in direction exactly like

picture shown above.

Table of Contents

Do you have a question about the 1800 and is the answer not in the manual?

Page 1 Solar Generator 1800 Trolley Installation Guide Thank you for purchasing Solar Generator 1800 Trolley, With convenient click & go design, moving Solar Generator 1800 around becomes never so easy. Please carefully read ALL below instructions during installation. Caution: Risk of injury To avoid muscle strain or back injury, use lifting aids and proper lifting techniques when moving the unit.
Page 2 Pull out the handle of the trolley, slowly lift it up to 30 degree angle until a click sound is heard, unit will automatically slide and is locked to the trolley. UNINSTALL the Trolley from Solar Generator 1800 UNIT FRONT SIDE UNIT BACK SIDE...