External Audio Device - Philips HTB5520/93 User Manual

Note
AM and digital radio are not supported.
•
If no stereo signal is detected, you are
•
prompted to install the radio stations again.
1
Connect the FM antenna to the FM
ANTENNA on your home theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press SOURCE repeatedly to switch to
radio source.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press
install radio stations.
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button Action
/ Select a preset radio station.
or
Alphanumeric
buttons
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
EN
20
(Play) to
Button Action
Manual:
1) Press
2) Press
3) Press
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE /
Toggle between the stereo
AUDIO
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press SOURCE repeatedly to switch to
radio source.
2
Press .
3
Press and hold
50 kHz or 100 kHz.

External audio device

Connect an external audio device to play audio
files.
What you need
• An external audio device with 3.5mm jack.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the external audio device to
AUDIO IN the connector on your home
theater.
2
Press SOURCE repeatedly until AUDIO
IN appears on the display panel.
3
Press the buttons on the external audio
device to select and play audio files.
.
/ to select your
preset.
again to store the
radio station.
(Play) to toggle between