Gardeners Titan A-Frame Trellis Quick Start Manual

Growing squash and cucumbers on a trellis saves space, reduces disease problems and makes harvesting a breeze. Titan A-Frame
Trellis is made from polyethylene-coated steel that will last for years to come. The polyethylene is non-degradable and provides a
clean look while protecting the steel from the elements. The steel tubing provides strength and durability, yet is also lightweight and
easy to assemble.
Parts List
(2) Top Supports
(4) Staked Supports
(4) Support Connectors
(11) Trellis Braces
(20) Sure-Clips
(10) Net Clips
(1) Netting
NOTE: Assembly is easiest with 2 people.
Step 1. Identify and organize all parts on a clean, level surface.
Step 2. Form one side of the Trellis by attaching two Staked Supports to a Top Support using
the Support Connectors (Figure 1). Repeat to make the other side of the Trellis.
Step 3. Place a Trellis Support into the clips on top of the Side Supports, as shown in Figure 2.
Carefully stand the Trellis upright, spreading the legs apart to keep it stable.
Step 4. Place a Trellis Brace against one side of the Trellis approximately 14"
from the bottom, as shown in Figure 3. Attach it to the Staked Supports using Sure-Clips
and the instructions below:
Tip: When attaching a Trellis Brace using the Sure-Clips, remember that the Brace should always be on the
outside of the Trellis and that the curved part of the Clips (Figure 4) will always be facing towards the
inside of the A-Frame Trellis.
Slide the looped end of a Sure-Clip over one end of the Brace (Figure 3) and position it so the rounded part
of the Clip fits around the side of the Trellis. Bend the open ends of the Clip around the Trellis Brace,
securing the Sure-Clip into place. NOTE: This may take some extra strength as the Clips are made to be
tight. Repeat to attach the other side of the Brace.
Step 5. Repeat Step 4 to attach another Trellis Brace to the other
side of the Trellis.
#8595755
Titan A-Frame Trellis
Assembly
over please
Figure 3
Trellis Support
Figure 2
Trellis Support
Side Supports
Sure-Clip
Side Support
Figure 1
Top Support
Support
Connectors
Staked
Supports
Figure 4
The curved part of the Sure-Clip will
always be facing towards the inside of
the A-Frame Trellis.
1024V Rev 05/21