Advertisement
Quick Links
Instructions for Self-Watering Elevated Cedar Planter Box and
Self-Watering Insert for Elevated Cedar Planter Box, 2' x 8'
Planter Box Parts List
(4) 8' CEDAR BOARDS
(4) CORNERS
(2) PLATFORM SUPPORTS
(4) FLAT STOCK
(3) CROSS SUPPORTS
(2) 2' END PANELS
(4) CORNER CAPS
(66) PHILLIPS SCREWS
Assembly Tools Required
Screw gun / drill with #2 Phillips bit
Phillips screwdriver
Rubber mallet or hammer
Tape measure
Clamp (optional)
Snips or shears (for Self-Watering System Assembly only)
Assembly is easiest with two people.
If you are retrofitting an existing 2' x 8' Elevated Cedar Planter Box, empty it out, remove the existing cedar floor, fabric liner, and
cross supports and skip to Part II: Self-Watering System Assembly. Keep the cross supports — you will reinstall them after you
connect and insert the water reservoirs. You will not need to reinstall the floor planks or liner.
I. Planter Box Assembly
1. Align the short edges of two 8' CEDAR BOARDS on a flat surface, (rough sides facing up) and clamp or hold them firmly together.
2. Slide a CORNER onto the ends of the CEDAR BOARDS, positioning it as shown in Fig. 1. The top CEDAR BOARD should come to sit
1/8" above the top of the CORNER.
3. Making sure there is no gap between the CEDAR BOARDS and that they are fully seated into the CORNER, secure with PHILLIPS
SCREWS. Leave the 2
hole from the bottom open for now. Repeat Steps 1-3 to attach another CORNER to the other end.
nd
4. Take a PLATFORM SUPPORT and place the face with 4 holes against the CEDAR BOARDS (Fig. 1). Align the holes on the ends with
the holes you left open in Step 3 and secure with PHILLIPS SCREWS.
5. Slide 2 FLAT STOCK underneath the PLATFORM SUPPORT and align holes as shown in Fig. 1. Secure the FLAT STOCK with PHILLIPS
SCREWS.
6. Repeat Steps 1–6 to assemble the other side panel.
Figure 1
#8609008 #8608960/*62/*65/*67/*68
8' CEDAR BOARDS
(rough faces)
CORNER
Self-Watering System Parts List
(3) WOODEN SPACERS
(1) FILL TUBE
(1) WATER LEVEL INDICATOR
(2) CAPS
PLATFORM SUPPORT
FLAT STOCK
1-800-876-5520 • gardeners.com
info@gardeners.com
Assembled Planter Box
(3) CONNECTING
(4) RESERVOIRS and
RESERVOIR TOPS
TUBES
holes
The top CEDAR
BOARD should sit
1/8" above the
CORNER.
LIT SKU# 8609459 | 1379G Rev 03/2020
Advertisement
Summary of Contents for Gardeners Self-Watering Elevated Cedar Planter Box
- Page 1 Instructions for Self-Watering Elevated Cedar Planter Box and Self-Watering Insert for Elevated Cedar Planter Box, 2' x 8' 1-800-876-5520 • gardeners.com info@gardeners.com Planter Box Parts List (4) 8' CEDAR BOARDS Assembled Planter Box (4) CORNERS (2) PLATFORM SUPPORTS (4) FLAT STOCK...
- Page 2 RESERVOIR TOPS to ensure good water-soil contact. Fill the RESERVOIRS using the FILL TUBE. You're now ready to plant! While plants are getting established, or in higher temperatures, water regularly from the top too. For video instructions, gardening tools, accessories, and advice — visit us at gardeners.com PLEASE...