Table of Contents
Advertisement
www.MercuryMagnetics.com
The "Holy Terror" Upgrade for the Orange"Tiny Terror"
Info@MercuryMagnetics.com
(818) 998-7791
Back panel view
Top view
GROUND
Lead
pass thru
MERCURY'S
POWER
TRANSFORMER
Lead
pass thru
ORANGE indicates new hole locations
~11-3/4" x 5-1/9" x 2" CHASSIS TOP and BACK PANEL VIEW (all specifications shown are nominal)
This project and its documentation are the result of technical investigations made by the engineering staff of Mercury Magnetics. The disclosure of the information herein may pertain to proprietary rights, and the furnishing of these documents does not constitute an expressed or implied license to use such materials.
Copyright © 2008–9 by Mercury Magnetics. All Rights Reserved. Mercury Magnetics, "Holy Terror" and the slogan "The Heart & Soul of Your Amp" are trademarks of Mercury Magnetics. Axiom and ToneClone are registered trademarks of Mercury Magnetics.
Chassis mods for Version 1 & 2 (Korean PCB), Version 3 & 4 (Chinese PCB) amps
EL84
(v4)
12AX7
(v2)
FRONT
Orange Amps and Tiny Terror are trademarks of Orange Amps. Mercury Magnetics is not affiliated with Orange Amps.
Pentode/Triode
Switch Location:
5-3/4"W x 1/2"H
from bottom
left corner
of chassis.
Use 1/4" bit.
EL84
(v3)
Lead pass thru
hole re-locations:
9-5/8"W x 3-1/2"H
from bottom
left corner
of chassis.
Use 7/16" bit.
Then, swap original
rubber grommets
to new holes.
12AX7
(V1)
1-3/4"
Center-to-Center
MERCURY'S
OUTPUT
TRANSFORMER
VERSION: 10-02-09
Advertisement
Table of Contents
