Advertisement
Table of Contents
- 1 Turn Machine on by Select a Cleaning Mode (Rug or Hard Floor)
- 2 If Machine Does Not Turn On, Refer to no Power Troubleshooting
- 3 Recline Machine to Activate Brush Roll
- 4 Check Ends of Brush Roll for Wrapped Debris or Hair
- 5 If the Brush Doesn't Spin, a New One Needs to be Ordered
- 6 Reattach the Brush Roll Window
- Download this manual
My CrossWave® Cordless Multi-Surface Wet Dry Vac
shuts off automatically | Support
•
Turn machine on by select a cleaning mode (Rug or Hard Floor)
•
If machine does not turn on, refer to
•
Remove the handle by using a screwdriver or other blunt object to press the white tab found behind
the clean tank
•
o
Pull up on the handle to remove
o
Reinsert handle into the machine - you should hear a click when secure
No power
troubleshooting
Advertisement
Table of Contents
Related Manuals for Crosswave Cordless 2588F
Summary of Contents for Crosswave Cordless 2588F
- Page 1 My CrossWave® Cordless Multi-Surface Wet Dry Vac shuts off automatically | Support • Turn machine on by select a cleaning mode (Rug or Hard Floor) • No power If machine does not turn on, refer to troubleshooting • Remove the handle by using a screwdriver or other blunt object to press the white tab found behind the clean tank •...
- Page 2 • Recline machine to activate brush roll If brush roll does not turn or machine shuts off after a short time turn machine off by pressing the Hard Floor button • Remove brush roll window by grabbing the pull tab and pulling upward •...
- Page 3 • Check ends of brush roll for wrapped debris or hair • Hold the colored pull tab on brush roll and spin the other end If the brush doesn't spin, a new one needs to be ordered...
- Page 4 • Check the plastic gear end on the machine and remove hair or debris wrapped in this area Turn gear by hand to test spin • Reinstall the brush roll by inserting the gray tipped end into the right side of the machine and then pressing down on the colored tab until it clicks into place •...
- Page 5 • Turn machine on, recline, and test to see if CrossWave turns on and will run If not, please contact us...
Need help?
Do you have a question about the Cordless 2588F and is the answer not in the manual?
Questions and answers