Troy-Bilt TB16R Operator's Manual page 6

Adjusting the Cutting Height
The cutting height can be adjusted to between approximately
1-inch and 21/2-inches (25.4 - 63.5mm).
1. Move the right-hand height adjustment lever outward and
then position it forward (to lower the cutting height) or
rearward (to raise the cutting height) before releasing it
into the notch for your desired height. See Fig. 3-4.
2. Repeat Step 1 on the left-hand side making sure to release
the height adjustment lever into the corresponding notch.
6 S 3 — A
ection SSembly
Figure 3-4
& S -U
et p
Attaching the Grass Catcher (Model TB18R)
1. Expand the grass catcher from its collapsed position by
opening up the hinges found on the inside of its frame.
2. Position the grass catcher hooks over the rod on the rear of
the mower. See Fig. 3-5.
Figure 3-5
3. Position the strap through the grass catcher's handle and
over the mower's lower handle crossbar to support the rear
of the grass catcher. See Fig. 3-6. Adjust the length of the
strap so that the bag is low to the ground but not dragging
on the ground.
Figure 3-6