Table of Contents
Advertisement
4.
Open the mechanism by
pressing the Locking Tenon,
plug in the cable connector of
the cutter module (29) onto
the switchboard socket.
Note: There are 2 sockets on the
converting boards (one is for
stripper installation, another is
for cutter installation), before
plug the connector into socket,
please check the pin first.
5.
Clip in the right side of the
cutter module (29) first, then
secure the left side.
6.
Flip the cutter module (29)
down to open the cutter.
Note: Please refer to photo (A).
16
(A)
Advertisement
Table of Contents
