Advertisement
Tip replacement
Note: Tip replacement or cleaning should be done only when the iron is at room temperature or below. The tip can
be changed or replaced simply by unscrewing the knurled nut barrel assembly. The station must be switched off
and allowed to cool before and during this operation, as damage may result if the system is left on without the tip
inserted, after removing tip, remove any oxide dust that may have formed in the tip retaining area of the barrel. Be
careful to avoid getting dust in your eyes. Care should be taken not to over tighten as this would damage the
element.
General cleaning
The outer case of the iron or station may be cleaned with a damp cloth using small amounts of liquid detergent
Never submerse the unit in liquid or allow any liquid to enter the housing. Never use solvent to clean the case.
Warning
The appliance is not a toy, and must be kept out of children's reach.
Before cleaning the appliance or changing the filter, always unplug it. Unscrewing the housing is not
permitted.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Note: This instruction is also available to download from the distributor's website:
www.doss.com.au.
Advertisement
