Download Print this page

Razor W15156208003 Replacement Instructions

Hovertrax prizma battery

Required Tools: (Not included)

A. Phillips screwdriver

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any

assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Flip the unit over and using a Phillips screwdriver,

remove the six screws from the cover without the

charger port/switch.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.

B. 4 mm Allen wrench

Lift up the cover being careful not to pull the wires and

set cover aside.

HOVERTRAX PRIZMA

BATTERY REPLACEMENT

INSTRUCTIONS

PART# W15156208003

Table of Contents

Need help?

Do you have a question about the W15156208003 and is the answer not in the manual?

Page 1 Lift up the cover being careful not to pull the wires and remove the six screws from the cover without the set cover aside. charger port/switch. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
Page 2 • Re-connect the yellow connector to the battery. • Put down the cover and re-attach the six (6) screws. Attention: Charge battery 6 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.