Ritron DATAFLOW RTU Technical Manual page 43

Load the FULL SCADA CONFIG, using RTU Programming Software. The configuration
is stored in RTU RAM, which has a large capacitor to hold the information in memory for
an extended period of time - 3 months or longer. If the stored configuration is lost, reload
it with the RTU Programming Software.
6.4.l If the application requires a MODBUS controller to download the FULL SCADA CONFIG,
consult RITRON for the proper procedure. This procedure varies depending on the type of
MODBUS controller you are using.
7.
TECHNICAL NOTES
system, use unit ID's or MODBUS addresses from 40 to 255 only. Communication errors may
7 .1
CLEARING SERIAL RESPONSE DELAY for Firmware Version 3.27 or later: this note explains
how to set the DATAFLOW RTU serial response delay to O (zero). DATAFWW RTU
configuration can be changed either before or after programming the serial delay. (Any other aspect
of Configuration. except Serial Response Delay, is accessed from the Configuration Screen.)
7. 1.1 From the Main Screen, press "3" to select Utilities.
7.1.2 From the Utilities Menu, press "1" to select EEPROM Block Edit.
7.1.3 Press "3" to Upload.
7.1.4 Type the hexadecimal value "00" (zero, zero) into Location OIA6. See Figure Bl, below.
7.1.5 Press ''F4" to download the data to theDATAFLOW RTU.
7. 1.6 Press Fl O" to Exit the EEPROM block edit screen.
7.1.7
Press "R" to return to the Main Screen.
result from using ID's and addresses from 1 to 39.
For Firmware Versions earlier than 3.25
**************
www.TwoWayRadioEquipment.com | (800) 878-7829 | Sales@TwoWayRadioEquipment.com
I
1 = ===== = = 1
1s o 100
1so11 0 !========!
1--------1-----------------------------------------I
1so120 !====== == !
I so1ao I======= = I
I s o 1•0 1 ====== ==1
I so1so I======== I
1souo I=====
1souo I===
I xxxx =
I sou.o
l$01.BO I== =
j $01CO I ======= = I
I $01DO I ==== == = = I
j$01EO l===== = = =I
j$01FO l===== == = I ·
CAUTION:
RTO EEPROM CONFIGO'RATZON SCREEN
Device ID: 01
(Address
-0-1 -2-3 -4-5 -6-7 -8-9 -A-B -C-D - E -F
:x::icct
Figure B1 - Configuration Screen
(released in the 2"d quarter of 1998), in a SCADA
= = I
oo xx xxxx = x:xxx = I
= = = = I
**************
File Na.me: DEFAULT.en£
I
DATAFLOW RTU
( B-13}