Advertisement
DC Motor Super Slim Series
MODEL
ODDSS-100-3 | ODDSS-100-3HS
INSTALLATION GUIDE
Assembly Instructions
1. Before installation, you need to know:
When installing contractor packs, make sure to install any optional
module such as speed controls or humidity sensors with the fan
housing to ensure wiring is completed properly. Module and grille
plugs come packaged with the optional accessory and MUST be
installed with the fan housing
2. Mount with Mounting Holes
Hold housing in place so that the housing contacts the bottom of
the joist. Screw housing to joist through the hole A and hole B
3.
4. Mount to I-joist
Slide hanger bar into the channel on the housing and adjust as
needed to fit I-joist. Hold housing in place so that the housing
contacts the bottom of joist. Screw housing to joist through the
hole A and hole B. Screw the hanger bar onto the joist through its
hole. Screw hanger bar to housing with screw A
info@ortechindustries.com
www.ortechindustries.com
1.
Turn the switch I ON
2.
Turn the switch II ON — fan will run at the certified airflow
rate
3. Mount with Mounting Holes
Slide one hanger bar into the channel on the housing and
adjust as needed to fit between framing. Hold housing in
place so that the housing contacts the bottom of the joist.
Screw housing to joist through the hole A and hole B. Screw
the hanger bar onto the other side of joist through its hole.
Screw hanger bar to housing with screw A
4.
5. Wall Installation
When the product is installed on the wall,
the adapter shall be faced upward.
13376 Comber Way
375 Admiral Blvd
Mississauga
Surrey BC V3W 5V9
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
