Inserting The Battery - Silvercrest HG00646A Operation And Safety Notes

Keep batteries away from children;
do not throw batteries in the fire,
short-circuit them or take them
apart.
If the above instructions are not
complied with, the battery may
discharge itself beyond its end
voltage. There is then a danger of
leaking. If the battery has leaked
inside your device, you should
remove it immediately in order to
prevent damage to the device!
Before first use
Removing the insulation strips
Note: The product is supplied with the battery
already in place. Before first use pull the insulation
strip out from between the battery and the battery
compartment.
Preparing for use

Inserting the battery

See Fig. G and
4
If the scales do not appear to work, check that
the battery has been inserted correctly and
reinsert it if necessary.
Note: The display indicates when it is time to
replace the battery. When you step on to the
scales and the battery is too weak, the LC display
shows "Lo" (see Fig. C) and the scales switch
off automatically.
If you see this message, replace the exhausted
battery with a new battery of the same type.
When you insert the battery, make sure that the
contacts do not get bent.
.
5
Setting the units of weight
Note: The standard unit of weight is kilogram (kg).
The factory default setting for the scales as supplied
is "kg".
Press the kg / lb / st button to select the unit of
weight. The units will be displayed in the LC
display as follows:
Kilogram (kg): see Figure A
Pound (lb): see Figure E
Stone (st): see Figure F
Switching on your scales /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
Place the scales down on a solid, flat horizontal
surface.
Step on to the scales.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform each time and do not move. Moving
during the weighing process can lead to
discrepancies in the results.
The scales will start to measure immediately.
After blinking 3 times, the weight display will
display the result, as shown in, for example,
Fig. B.
Note: If the scales show "oL" (see Fig. D), it
signals that the scales are overloaded. Observe
the maximum capacity of 180 kg (396 lb / 28 st).
Step off the platform. The scales switch off
automatically after about 10 seconds. Until
then the weight measurement remains visible.
Note: After a change of location and follow-
ing every battery change, the scales must be
re-calibrated. To do this, proceed as follows:
Step onto the scales. The scales will show you
an incorrect measuring result. Step off the plat-
form. The scales will calibrate automatically.
GB 7