BRC ARM25P Instructions For Use Manual page 2

POSITIONING
This device is only made to be used indoor and must be installed in vertical
position. It has to be fixed to the wall at more the less than 1.30m, preferably
in an accessible and clean area.
The units must only be used in areas which are free of dust and possible explosive
vapour mixture. Should you have any queries contact your local reseller for advice
before installation.
INSTALLATION
1. Fix the 3/4 screws and dowels according to plan bellow
2. Hang it by sliding screw's heads into corresponding holes
3. Open the door and tighten the screws to lock fixing
4. Connect the appliance to a power outlet corresponding
to the power requirements
5. A sterilizing cycle will start automatically.
MODELS ARM25 A/P ARM50 A/P ARM100 A/P
A 230mm
SERVICING
Changing of the UV-C bulb by any non-qualified user is strictly forbidden. Before any form
of servicing, even like bulb replacement, the unit must be disconnected from the mains supply.
To maintain the sterilizing efficiency, the UV-C bulbs have to be replaced once a year.
CLEANING
The internal cleaning of this device can only be made by using a slightly damp towel. Any
internal or external water projection have to be avoided.
GUARANTEE
Your unit is guaranteed for 2 years (excluding bulbs replacement). If a fault occurs, contact your
supplier, who will replace your unit checking that the product has been operated under normal
conditions.
MODELS
Maximum knives
Knives fixing
UV bulb
Height (mm)
Depth (mm)
Width (mm)
Weight (kg)
Page 4 sur 12
info@brcsa.com - Tel. 02 40 34 57 24 – Fax. 02 40 34 74 76 – www.brcsa.com
380mm
ARM25P ARM25A
12 7
Rack Magnet
1x15W 1x15W
593 593
145 145
345 345
5,5 kg 5,5 kg
BRC SAS – 21 rue des coteaux de Grand Lieux – 44830 BOUAYE
A = 800mm = B
ARM50P ARM50A
20 10
Rack Magnet
1x15W 1x15W
593 593
145 145
495 495
6,5 kg 6,5 kg
A
B
ARM100P ARM100A
40 20
Rack Magnet
2x15W 2x15W
593 593
145 145
939 939
11,5 kg 11,5 kg
25.06.2019
Indice C