Related Manuals for Shark NV44
Summary of Contents for Shark NV44
- Page 1 NV44 Owner’s Guide www.sharkclean.com NV44_26_IB_E_130124_1.indd 1 13-01-24 11:35 AM...
-
Page 2: Technical Specifications
NV44 26 TECHNICAL SPECIFICATIONS Voltage: 120V. Watts: 1200W Amps: 10A Hertz: 60Hz Euro-Pro, Shark, and Navigator are trademarks of Euro-Pro Operating LLC. All other brand names may be trademarks of their respective owners. TOLL FREE: 1-800-798-7398 NV44_26_IB_E_130124_1.indd 2 13-01-24 11:35 AM... - Page 3 Contents Thank you for Important Safety Instructions purchasing Getting Started the Shark ® Using the Vacuum Navigator ® Cleaning with the Vacuum Accessories Plus Upright Vacuum. Emptying the Dust Cup Assembly Proper Care of Your Vacuum Troubleshooting Checking for Blockages...
-
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK NAVIGATOR GENERAL ELECTRICAL SAFETY: ® ® PLUS UPRIGHT VACUUM, BASIC SAFETY 1. Unplug from electrical outlet when not in use PRECAUTIONS SHOULD ALWAYS BE and before servicing. FOLLOWED, INCLUDING THE FOLLOWING: 2. -
Page 5: General Use
GENERAL USE: GENERAL CLEANING: 25. DO NOT run the vacuum over large-sized 17. Use only as described in this manual. objects. 18. DO NOT put any objects into openings. 26. DO NOT pick up hard or sharp objects such as 19. -
Page 6: Getting Started
Getting Started Along with your upright unit, you Your Shark Navigator Plus ® ® Slide the handle assembly will find the following components: Upright is easy to assemble: into the upright unit aligning the hose hook on the handle Vacuum Body... - Page 7 To carry the vacuum: Attach the Super Stretch Hose: When storing your vacuum, wind cord around the two cord With the unit in the standing Snap hose into swivel holders and secure with cord connector position, lift by the Dust Cup clip: Assembly Handle (carry handle).
-
Page 8: Using The Vacuum
Using the Vacuum Bare Floors / Tools Carpets Your Shark Navigator Plus ® ® When cleaning bare floors: IMPORTANT: Upright Vacuum is a versatile tool Your Brush Roll Indicator Light Select the “I On” position for that can be used to clean bare floor... -
Page 9: Cleaning With The Vacuum Accessories
Cleaning with the Vacuum Accessories Vacuum Accessories Using the Cleaning Wand: Your vacuum comes with a Super Stand the vacuum into upright Stretch Hose and Cleaning Wand. position. Before cleaning with your Use one or the other to attach your Remove the Cleaning Wand accessories: cleaning accessories. -
Page 10: Emptying The Dust Cup Assembly
Option A: for Quick Empty: this material before continuing Locate the Dust Cup Door Insert Dust Cup Assembly deep to vacuum; Shark advanced ® release button within the trash inside trash receptacle to contain cyclonic action will sweep the bag and press to release as you dust and debris. -
Page 11: Proper Care Of Your Shark
Proper Care of Your Shark Upright Vacuum ® COMPONENT MAINTENANCE SCHEDULE Dust Cup Empty each time you vacuum. Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use. Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use. -
Page 12: Troubleshooting
Troubleshooting WARNING: To reduce the risk of electric shock, the power cord must be disconnected before performing maintenance/troubleshooting checks. PROBLEM POSSIBLE REASONS & SOLUTIONS Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Vacuum is not Dust cup may be full;... -
Page 13: Checking For Blockages
Checking for Blockages Blockages may cause your vacuum to overheat and shut down. If so, clear the blockages, then follow the instructions for Resetting the Motor Thermostat on page 12. WARNING: Never insert sharp objects into any opening to clear an obstruction. -
Page 14: Maintenance
Maintenance Resetting the Motor Thermostat Your Shark Navigator Plus ® ® Upright Vacuum is equipped with a protective Motor Thermostat. If the motor should overheat, the thermostat shuts off the power. Cleaning the Power Brush - Turn the Power Brush over and slide locking latch (A) forward. -
Page 15: Product Registration
Product Registration Please visit www.sharkclean.com or call 1-800-798-7398 to register your new Shark product within ten (10) ® days of purchase. You will be asked to provide the store name, date of purchase and model number along with your name and address. - Page 16 CAN: 4400 Bois Franc, St-Laurent, QC H4S 1A7 English: 1-800-798-7398 www.sharkclean.com Copyright © Euro-Pro Operating LLC 2013 Euro-Pro, Shark, and Navigator are trademarks of Euro-Pro Operating LLC. All other brand names may be trademarks of their respective owners. Printed in China Illustrations may differ from actual product.