Table of Contents
Advertisement
SSID
Channel
Basic Rate
Connect: You can select the wireless access point you wish to
connect here.**
SSID: the SSID of all found wireless access points will be
shown here. Some wireless access point may hide their
SSID, in this case, you have to identify them by their MAC
address.
MAC Address: If you there are many wireless access points in
proximity or some wireless access point hides it's SSID, you
can use MAC address to distinguish them.
Signal: Shows the radio signal strength in percent.
Channel: Shows the radio channel of this wireless access
point.
Encryption: Shows the encryption type used by this wireless
access point. You must use the same encryption type if you
wish to connect to a certain wireless access point. If the
wireless access point does not use encryption, 'Disabled' will
be displayed here.
Network Type: Shows the network type of a certain wireless
access point (Infrastructure or Adhoc).
Input the SSID of the wireless access point you wish to
connect. It should be less than 32 alphanumerical characters.
When you select a wireless access point above, it's SSID will
be filled in this field automatically. However, if the SSID is not
displayed (the wireless access point you selected choose to
hide it's SSID), you have to know it's SSID and input it here, or
you will not be able to connect it.
Select the radio channel you wish to use here. When network
type is 'Infrastructure', the radio channel is auto-selected
according to the channel that wireless access point uses. You
can only select the channel number when network type is
'Adhoc'.
Select the maximum wireless data transfer rate here, from
Advertisement
Table of Contents
