Tripp Lite DWF2655X Owner's Manual page 5

2b. Mount on Solid Brick and Concrete Block
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or
"cinder block"), verify that the actual concrete thickness is at least 35mm (1-3/8")
in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS! Be sure
to mount the assembled wall-mount plate with the included concrete anchors, D6
washers and anchor bolts onto solid sections of the blocks. The solid sections can
generally be found 25mm (1") toward the middle of the block from either end. An
electric drill on a slow setting is suggested to drill the hole rather than a hammer
drill so as to avoid breaking out the back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
14-04-248-933327.indb 5
D6 Washer
Concrete Anchor
WARNING
5
1
exact location of
mounting holes
2
Drill pilot holes
Anchor Bolt
Screw the
assembled wall
plate onto the wall
5/6/2014 2:57:54 PM
Mark the