Installing The Antenna; Installing The Belt Clip - Kenwood TK-2170-K Instruction Manual

KENWOOD CORPORATION
TK-2170-K, TK-2170-K2 FCC ID:ALH34703110 / IC:282D-34703110
TK-3170-K, TK-3170-K4, TK-3173-K FCC ID:ALH34713110 / IC:282D-34713110
TK-3170-K3, TK-3170-K6 FCC ID:ALH34713130 / IC:282D-34713130

Installing the Antenna

Screw the antenna into the connector on the top of the transceiver by holding the antenna at its base and
turning it clockwise until secure.

Installing the Belt Clip

1 Remove the two screws from the rear of the transceiver, then remove the small, plastic black covering that was
held in place.
2 Insert the belt clip mount into the space on the rear of the transceiver.
3 Using the 2 screws, affix the belt clip in place.
Note: Do not dispose of the plastic black covering.
If you remove the belt clip, replace the covering into the space on the rear of the transceiver.
Either this covering or the belt clip must be in place, otherwise the battery pack may not remain installed properly.