Checking The Tire Pressure; Servicing The Battery - Toro Z Master Professional 2000 Series Setup Instructions

5

Checking the Tire Pressure

No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
Note:
Check the tire pressure before starting the
machine. Refer to your Operator's Manual for the
correct tire type and procedure.
6

Servicing the Battery

No Parts Required
Procedure
Important:
Do not run the machine with the
battery disconnected; electrical damage may
occur to the engine.
1. Charge the battery. Refer to the Operator's
Manual for instructions.
2. Connect the negative battery cable.
Note:
If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black)
cable to the negative battery terminal. Slip the
insulator boot over the positive terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount (Figure 2).
1. Ensure that the ground
cable does not rub against
the lower shock mount.
2. Ensure that the ground
cable does not rub against
the trailing arm.
3
Figure 2
3. Ground cable
g236732