Related Manuals for Value Hobby EliteModels Proglide
Summary of Contents for Value Hobby EliteModels Proglide
- Page 1 2-Meter Proglide Powered Glider ARF Specifications Wingspan: 78.7 in (2000mm) Length: 39 in (1000mm) Weight (kit): 750...
- Page 2 Value Hobby guarantees this model to be free of defects in materials and workmanship at the date of purchase. This warranty does not cover any parts damaged by use or modifications. In no way shall Value Hobby’s liability exceed the original cost of the purchased model.
- Page 3 Before Starting Assembly Unpack your airplane and examine the components. Check for damage of any kind. If you see any damage, please contact Value Hobby immediately. Airframe Parts 1. Fuselage 2. Right wing 3. Left wing 4. Vertical fin 5. Elevator 6.
-
Page 4: Recommended Equipment
RECOMMENDED EQUIPMENT Product Quantity Microzone MC6C 2.4GHz 6CH Transmitter VHB-AC-5941 Value Hobby 9 x 5 Electric Folding Prop HYE-MP-2843 GForce 30A Brushless ESC VHB-SC-4496 GForce 30C 800mAh 3S 11.1V LiPO (T-Connector) RFI-LP-708 Power HD 1501MG Metal Gear Standard Servo... - Page 5 Locate the following parts: the vertical fin plate on the vertical fin and draw a line along the edge. 2 x Z-Bend Wire 1 x Vertical Fin Plate 2 x Servo Plate 2 x Control Horn 2 x Vertical Fin Screw Servo Connector 2 x Servo, at least 50oz of torque...
- Page 6 Apply the CA glue to the opening. Apply the CA glue to the opening of the fuselage. the vertical fin plate onto the elevator Then secure the tail onto the fuselage. Secure vertical fin onto the elevator with Then secure the Note: As shown, when finishing the installation.
- Page 7 servo connector on servo arm. Install the Insert the Z-bend wire into the pre-cut hole of the fuselage. Secure the Z-bend wire into the control horn. Then Install the servo into the fuselage. secure the control horn on the pre-cut slot of the vertical fin with CA glue.
- Page 8 Cut off the excess part of the control horn with a knife. Cut off the unnecessary part of the Z-bend wire. Then secure the control horn on the pre-cut slot of elevator with the CA glue. Locate the following parts: 1 x Cabin cover Velcro strip (Not...
- Page 9 Secure the cowling onto the fuselage with CA glue. Locate the following parts: 1 x Wing joiner strip 2 x Rubber band 2 x Wing dowel Install your prop in the motor. Apply the epoxy to the wing joiner strip and the joint areas of the wing (Side A, B and C).
- Page 10 After applying the glue, put the joined wing on a flat surface. Wait for the glue has cured. Secure the wing dowel into the pre-cut hole on the fuselage with CA glue. Secure the wing on the fuselage with the rubber band. The CG should be 60mm (2.3-2.4in) from the leading edge of the wing.