Related Manuals for Value Hobby Elite Models Drifter Plus
Summary of Contents for Value Hobby Elite Models Drifter Plus
- Page 1 Drifter Plus Park Flyer Kit Specifications Wingspan: 37.4 in (950mm) Length: 33.5 in (850mm) Flying Weight: 500g...
- Page 2 Value Hobby guarantees this model to be free of defects in materials and workmanship at the date of purchase. This warranty does not cover any parts damaged by use or modifications. In no way shall Value Hobby’s liability exceed the original cost of the purchased model.
- Page 3 Before Starting Assembly Unpack your airplane and examine the components. Check for damage of any kind. If you see any damage, please contact Value Hobby immediately. Airframe Parts 1. Main wing 2. Nose section Canopy 4. Vertical fin 5. Elevator 6.
- Page 4 (12 pieces) Screw 17. Φ1*260mm Z-bend wire 18. Landing gear wire, 19. Carbon fiber tube 20. Foam safe glue RECOMMENDED EQUIPMENT Product Quantity FrSky Taranis Q X7 Transmitter and Receiver Set FRY-RC-5938 Towerpro SG90 TWP-SV-0357 GForce E400 2212-2200KV Brushless Motor VHB-MT-5337 GForce 30A Brushless ESC VHB-SC-4496...
-
Page 5: Section 1 Fuselage Assembly
Section 1 Fuselage Assembly Locate the airplane nose section, the canopy, the Put the carbon fiber tube go through the pre-cut hole fuselage frame, and the carbon fiber tube. on the fuselage. Apply the foam safe glue to the front of the carbon Apply the foam safe glue to joining area on the nose fiber tube and secure the carbon fiber tube in the pre- section. -
Page 6: Section 2 Wing Assembly
The fuselage assembly is finished. Secure the control horn into the slots. Section 2 Wing Assembly Place the wing on the wooden fuselage frame and secure it with two screws (M3*3.5mm). Locate the following parts: 2 x Z-bend wire(Φ1*260mm) 4 x Carbon fiber wing support plate 2 x Wing fixed screw(M3*3.5mm) 2 x M3 wing washer 8 x Support plate fixed screw(M2.5*10mm) -
Page 7: Section 3 Empennage Assembly
Then secure wing support plate on the wing with Place a micro servo into the servo slot on the wing and support plate fixed screw. secure it with two servo screws. Repeat the pervious steps for three remaining wing Join Z-bend wire with the servo arm. Then connect this support plates installation Z-bend to the control horns. - Page 8 Apply the foam safe glue to the pre-cut slot on the Apply the foam safe glue to the pre-cut slot on the top vertical fins surface of the elevator. Install the control horn in the pre-cut slot on the vertical Install the vertical fins into the pre-cut slot on the fins elevator wing.
-
Page 9: Section 4 Tail Servo Assembly
Connect the elevator servo to the Z-bend wire and then to the elevator control horn. Two Z-bend wires should be paralleled. Section 4 Tail Servo Assembly Locate two elevator servos (Not include). Section 5 Power System Installation Locate a 6*4 propeller, a 30A ESC, a 2212-2200KV motor. - Page 10 Install 6*4 propeller into your motor. Install two tires on the landing gear wire. Lock the tires in place with the supplied wheel collars. Connect 30A ESC to your motor. Then put the ESC into the wooden fuselage frame. Install the landing gear into the slot on the bottom of the fuselage.
- Page 11 The CG should be 60mm (2.3-2.4in) from the leading edge of the wing.