Urban H7 Quick Manual

QUICK GUIDE MILKSHUTTLE
I PREPARATION OF FEED:
Fill the required amount of water or whole milk into the container of the MilkShuttle.
Keep H /a
eating
°C/F
up of heating process until target temperature is reached (+ post heating if needed):
Key
clock timer running (optional)
Heating/
Agitating
1:Heating auto mode
1:17:00
Start time heating
Start (of heating) in hh:mm:ss
b) Preparing / mixing calf milk replacer
(not applicable if whole milk is used)
I I
Set the agitator switch to level II (fast mode) while preparing feed from calf milk replacer.
0
I
Press Start/Stop key. The agitator will then run in continuous mode (5 mins.). Fill the
START
required amount of milk powder into the heated water and let stir in.
STOP
II DISPENSING THE PREPARED FEED
Keep F key pressed for 2 seconds, this will call up the feeding mode:
eeding
Key
key pressed
F
eeding
for quantity
selection
feed quantity dispensed: target value / actual value
Press key 1, 2 or 3 in order to select the desired feed quantity to be dispensed.
1
To dose out portion in bucket press Start/Stop button on the dosing nozzle or the red
Start
push button on the drawbar head or the Start/Stop key on the membrane keyboard.
Stop
III CLEANING
Roughly wash off the inside of the container and the agitator. Then fill the container
with approx. 30 l of water, add detergent if needed.
Establish circular flow system for cleaning by inserting the dozing nozzle into the holder
on the inside of the container lid.
Keep the C
leaning
selected cleaning
K
ey
program
W
aSHing
(via key 1, 2 or 3)
duration of cleaning cycle (minutes)
Press the S /S
tart
value for the temperature of the cleaning water was set, water will be
START
STOP
heated first.
When the cleaning process is completed, the C
ing cycle is completed, open the drain valve using the valve lever at the top of the
valve. Let the cleaning water drain completely. Then rinse with clear water.
Urban GmbH & Co. KG • Telefon +49 (0) 4484/9380-0 • www.milkshuttle.de
a) Filling and heating up water / whole milk
key pressed for 2 sec: actvation of clock timer or immediate start-
gitating
target temperature
start time
Heating 40.0°C
(here:
active
5:00 pm)
Feeding
1: 02.0 00.9
key pressed for 2 seconds, this will call up the cleaning mode:
Cleaning
1: 05:00
key in order to start the cleaning cycle. If a target
top
For DIMA firmware 3.x starting with serial no. H7
25.9°C
actual temperature
Heating Agitating
charge condition:
battery 2 (propelling drive only)
█████
battery 1
█████
cleaning water temperature
45.0 C
33.0 C
Active agitator
key will flash. After the clean-
leaning
Heating Break
00:15
Agitator activity during
heating process
00:06
remaining time
see reverse side
target value
actual value
°C/F
+
-
SET
target temper-
ature, duration
of agitating/
break
start time morn-
ing / evening
(3 time pairs)
START
STOP
+
-
SET
feed quantity
+
-
SET
duration
cleaning
cycle, target
temperature
(3 washing
programs)
Page 1