Subscribe to Our Youtube Channel
Related Manuals for Technics 00400
Summary of Contents for Technics 00400
- Page 1 ShrinkSTATION Machines 00400 ShrinkSTATION Operations Manual Complete Machine installation and troubleshooting guide. LIT-SFSTATION2016...
- Page 2 Important – Cautions & Warnings The Model 00400 has been constructed using the lat- Pay particular attention to the following Cautions and est technology and is extremely safe and easy to op- Warnings marked with the “Attention” and “Danger” erate. Despite that, there is still some danger if these symbols.
- Page 3 Important – Technical Notes ShrinkFIT Holding Power on Tool Shank Power Requirements & Heating Speeds Techniks Model 00400 operates on a 208-240 VAC, 15 amp, single phase power supply. Tool holders for smaller cutting tools require less power to heat, but must be heated to a higher temperature than larger tools to perform insertion and extraction.
- Page 4 • Tool moves to the optimum position for heating automatically Designed and built in Indianapolis, IN. ShrinkSTATION Includes: Part No. Description QTY. 00400 induction heat shrink fit machine 00165 induction stop ring (3-5mm) 00166 induction stop ring (6-12mm) select tool shank 00167...
- Page 5 00400 ShrinkSTATION Setup Guide Machine Setup Minimum Power Supply The 00400 ShrinkSTATION requires a level, stable surface and good 208 VAC, 1-phase 15 amp ventilation for proper operation. Keep the machine clean and dry at all times. Maximum Power Supply Connect the machine to your power supply.
- Page 6 Setup Guide / Operation Guide Powering up the machine Turn on the power switch located on the right side of the machine. Wait for the machine to display the input screen. You can press the Help button from any screen for more information about that screen’s functions.
- Page 7 Operation Guide Cooling Cycle The cooling cycle automatically begins 5 seconds after the heating cycle ends. The cooling cycle automatical- ly stops after 3 minutes. You can manually stop the cooling cycle after 30 seconds by touching the “Head Air Off” button. Touch the “Head Air On”...
Need help?
Do you have a question about the 00400 and is the answer not in the manual?
Questions and answers