Advertisement
Assembly
1. Before assembling, clean the threads and lines. Make sure that no contaminants may get into
the pressure line.
2. Make sure that the air flows into the direction of the arrow found on the product. Before use, re-
check all connections.
3. Pressure regulation: Pull the knob upwards and turn it clockwise to increase the pressure.
Turn the knob counter-clockwise to reduce the pressure. Once the desired pressure is set, press
the knob to lock it.
4. Drain: The water can be drained automatically when there is no pressure build-up. If pressure
has built up, the water is drained by pressing the water drain knob. After draining the water,
release the knob to stop drain. In case the water level exceeds its maximum, immediately drain
the water by hand, for otherwise the drain line might deteriorate.
5. Oil quantity regulation: The oil drain is reduced by turning the needle valve clockwise. The oil
drain is increased by turning the needle valve anti-clockwise. Once the needle valve is adjusted,
the oil drain adapts to the air flow.
6. Re-filling: Re-filling can be done without interrupting the air flow. Untighten the oil screw coun-
ter-clockwise to re-fill. The level must not exceed 80 %. Re-tighten the oil screw after re-filling.
Do not remove the oil container itself for re-filling.
Maintenance
1. Clean/replace the filter: Remove the filter, let the air escape from the inside to outside. The
filter is now operational again.
2. Transparent plastic cap: Remove the plastic cap to clean it with a dry and clean cloth. Do not
use chemical products that might with plastics.
Manufacturer's codes
A2000
Model
AC FRL combination
AF filter
AW filter regulator
AR regulator
AL lubricator
Important note!
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
01
Threaded connection (RC)
M5–M5
01–1/4
02–1/4
03–3/8
04–1/2
06–3/4
10–1
Item 51362
Page 5
09
2021-1
Advertisement
