U-Line H-1244 Quick Start Manual

HORIZONTAL PAPER
CUTTER WITH
SERRATED BLADE
Figure 1
Figure 2
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
ASSEMBLY
TO ASSEMBLE FOR COUNTERTOP USE
1.
2. Insert the included rubber feet into the holes on the
3. Set the cutter upright (rubber feet down) on the
4. Remove the dowel and slide it through the core of
5. Place the exposed ends of the dowel into the dowel
6. Feed material through the underside of the blade to
Pour le français, consulter les pages 5-6.
Remove paper cutter from box and grasp the
bottom crossbars. Pull these crossbars apart until
they lock in the open position. (See Figure 1)
NOTE: Use caution when unpacking paper
cutters with serrated blades.
bottom crossbars. (See Figure 2)
workstation. With one hand on the dowel, pull the
blade towards the workstation top until the blade
locks into the open position. (See Figure 3)
NOTE: Blade is spring loaded. Use exceptional
caution with serrated blade units.
the material intended for use on the cutter. Core
plugs with 1" openings are included and are
recommended for use with this product.
sockets, one on either side of the cutter. Then,
carefully push the blade toward the material until
the blade rests securely against the roll.
dispense and tear.
Para Español, vea páginas 3-4.
0521 IH-1244