Download Print this page
Sealey LED318 Series Quick Start Manual

Sealey LED318 Series Quick Start Manual

Rechargeable inspection lamp

Advertisement

Quick Links

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. saFetY
1.1.
general saFetY
ensure the lamp is fully charged before initial use.
9
do not turn the lamp on when it is being charged.
8
do not shine directly into your, another person's or an animal's eyes.
8
do not allow children to use the lamp.
8
do not handle or move the lamp whilst it is being charged.
8
do not use the lamp if you suspect that the battery or the lamp casing is damaged.
8
do not leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2.
batterY saFetY
warning! To reduce the risk of burns or fire:
do not attempt to open, disassemble, modify or service the battery pack.
8
do not crush, puncture, short external contacts or dispose of in fire or water.
8
do not expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2.
introduction
i
lightweight lamp. Featuring a super bright 5W CoB led light source, which gives an even and constant spread of light, producing up
to 400 lumens. 3W High power led torch producing up to 100 lumens. Integral hanging hook/belt clip with magnet and a magnetic base
which can rotate through 180° for hands free applications. Features a battery level indicator. Rechargeable 3.7V 2Ah li-ion battery for
longer life, no memory effect and a much slower discharge than traditional ni-mH batteries. Built in power bank to charge mobile devices.
micro USB charging port. Supplied with USB cable.
3.
speciFication
i
model no: ....................................................... led318 Series
Battery ...........................................................3.7V 2Ah li-ion
Charging Time ...................................................................3hr
led Qty ........................................................ 1 CoB + 1 led
length ........................................................................ 190mm
lumen outputs............................... Side - 400lm/Top - 100lm
operating time .........................................Side - 3hr/Top - 5hr
net Weight .................................................................. 0.22kg
important warrantY inFormation
The battery fitted to this lamp is considered to be a consumable item and its ability to
accept a charge will reduce over time. We will provide warranty against mechanical
and electrical defect for a period of one year - this does not cover fair wear and
tear. If the battery is not properly charged before first use, or regularly conditioned,
its capacity will diminish. Under these circumstances we will not replace the battery
regardless of whether it is less than one year old.
4. operation
Refer to fig.1
4.1.
Connect the USB lead to the socket on the side of the lamp. Plug USB lead into a
power supply and turn on.
4.2.
When the battery has fully charged the 5 GReen leds on the rear will illuminate.
4.3.
each led represents 20% of the charge level.
4.4.
direct the lens away from your eyes before switching on.
© Jack Sealey limited
rechargeable inspection lamp
5w cob + 3w led + power bank
led318 series
model no:
Original Language Version
fig.1
led318 Series
Issue 1
05/03/19

Advertisement

loading

Summary of Contents for Sealey LED318 Series

  • Page 1 IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey ltd’s Batteries Producer Registration number (BPRn) is BPRn00705.