Unpacking And Assembly; Installation - Viva 7LIECH-SC-SSF User Manual

ASSEMBLY
To prevent accidental tip hazard, base
supplied must be securely fixed to the
dispenser as shown.
Do NOT operate dispenser without base
properly installed.
Keep plastic bags away from children.
1. Remove dispenser from packaging.
2. Lay dispenser on its back.
3. Position cooler upright. Unpack drip tray and insert
into dispenser.
4. Properly dispose all of packaging.

INSTALLATION

Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
1. Locate the dispenser on a hard and level surface in a cool shaded location
near a grounded wall outlet.
2. Position dispenser so that the back is at least 4 inches from the wall and
there are at least 4 inches of clearance on both sides.
3. To minimize vibration and noise, make sure that the dispenser is flat.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-469-8482 for assistance
WARNING
7. C
Model # 7LIECH-SC-SSF:Page 6
4in. Min