Model # 7LIECH-SC-SSF:Page 2 SAFETY PRECAUTIONS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and your appliance. Always read and follow all safety messages. This is the safety alert symbol.
Model # 7LIECH-SC-SSF:Page 3 SAFETY PRECAUTIONS ---Electrical Requirements WARNING Electrical shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock.
Model # 7LIECH-SC-SSF:Page 4 TABLE OF CONTENTS Safety Precautions ............... Safety Precautions-Electrical Requirements ......Product Features ..............Key Information for Future Use ..........Specifications ..............Parts & Features ..............Unpacking and Assembly ............ Installation ................Cleaning Prior to Initial Use ..........
Model # 7LIECH-SC-SSF:Page 5 SPECIFICATIONS Power Supply 5 Amp Refrigerant Type R-134A 100 Watts Cold Water Power Cold Capacity / Hour 5 L / 1.32 Gallon Cold Temp Rang 3°C - 10°C / 37.4°F - 50°F Hot Water Power 425 Watts 4 L / 1.05 Gallon...
Model # 7LIECH-SC-SSF:Page 6 ASSEMBLY To prevent accidental tip hazard, base supplied must be securely fixed to the dispenser as shown. Do NOT operate dispenser without base properly installed. Keep plastic bags away from children. Remove dispenser from packaging. Lay dispenser on its back.
Model # 7LIECH-SC-SSF:Page 7 CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may have accumulated during shipment, you may want to clean the dispenser prior to first use. DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET AT THIS TIME.
Model # 7LIECH-SC-SSF:Page 8 INSTALLATION To prevent accidental tip hazard, dispenser must be securely anchored to wall as shown. Place dispenser upright. Locate dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet.
Model # 7LIECH-SC-SSF:Page 9 OPERATION IMPORTANT This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if used with any other liquids such as coffee, tea, juices, beer or wine.
Page 10
Model # 7LIECH-SC-SSF:Page 10 Dispensing Cold Water Note: After setup, it will take up to 1 hour to get the water t o its cold temperature. Compressor will run continuously for 2.5 hours. It will work to build up ice bank, this is normal.
Model # 7LIECH-SC-SSF:Page 11 PROPER CARE & DESCALING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. They may scratch surfaces and contaminate drinking water. For cleaning hard spots suggest rubbing with toothpaste.
Page 12
Model # 7LIECH-SC-SSF:Page 12 Once unit has completed draining replace drain cap and drain plug. Remove remaining water from cold reservoir by dispensing from both taps into a pitcher. Remove bottle receptacle or collar by turning it counter clockwise and pulling up. Store in a safe place.
Page 13
Model # 7LIECH-SC-SSF:Page 13 Descaling If you use mineral water you will need to descale your hot water tank. Heated mineral water will cause minerals to fall out. Eventually they will plug up your water- ways, resulting in a gradual slowdown of the flow rate, leaking faucets, and other problems.
Model # 7LIECH-SC-SSF:Page 14 TROUBLESHOOTING Problem: Stainless steel surfaces are smudgy or fingerprinted. Solution: Use paper towel to wipe excess oils until surface feels dry to the touch. • To maintain beauty of stainless steel, oil it periodically using a stainless steel cleaning solution available at hardware stores, or use mineral oil (unscented baby oil).
Model # 7LIECH-SC-SSF:Page 15 LIMITED WARRANTY Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructi- ons accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.