Kelkay 45000L Instructions

Easy Fountain Instructions

45000L - Enchanted Garden
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.

STAGE 1

Position the water feature onto a secure and level surface.

STAGE 2

As shown in the diagram above locate the access cavity / water reservoir at the back of the water
feature. Reach inside the feature and carefully bring out the internal water pipe and the LED cables.

STAGE 3

Attach the internal water pipe to the pump outlet and connect the internal LED wires to the adaptor
plug provided.

STAGE 4

Position the pump and excess wires inside the access cavity / water reservoir ensuring that the long
Pump and LED wire extend out through the opening. Replace the back trapdoor to cover the
opening.

STAGE 5

Carefully fill the feature with sufficient water taking care to ensure the pump is fully submerged.

STAGE 6

Connect the pump and LED adaptor to a mains power outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.