Kelkay Easy Fountain Monaco Tier Instructions

Easy Fountain Instructions
45009L - Monaco Tier
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
STAGE 1
Position the base section of the feature onto a secure and level surface.
STAGE 2
Following the diagram above, fix the large bowl onto the base of your water feature and lock it into
place.
STAGE 3
Thread the long wire which extends from the pump down through the white stand pipe into the base
of the fountain.
STAGE 4
Position the top section of the fountain over the pump ensuring that the LED light wire is connected
to the cable extending from the pump and the internal water tubing is connected to the pump outlet.
STAGE 5
Thread the transformer wire through the base of the fountain. Push the cable with 2 pins into the
transformer and screw over the plastic collar.
STAGE 6
Fill the fountain with sufficient water taking care to ensure that the pump is fully submerged.
Connect the plug to a mains outlet.
HELPFULL TIP
For levelling of tiered fountains always work upwards from the bottom.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.