AEG L7WEE741BI User Manual page 31

Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows
the desired delay time.
3. Touch the Inicio/Pausa button again
to start the new countdown.
10.8 The ProSense System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Inicio/Pausa button,
the ProSense System starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds. During this phase
the Time Save bars
below the time digits play a simple
animation, the drum rotates shortly.
2. The programme duration will be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
10.9 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the Inicio/Pausa button.
The related indicator flashes.
2. Change the options. The given
placed
3. Touch the button Inicio/Pausa again.
The washing programme continues.
10.10 Cancelling a running
programme
1. Press the button On/Off to cancel
is
2. Press the button On/Off again to
About 20 minutes after the
programme start, the
programme duration could
be adjusted again
depending on the capacity
of water absorption of the
fabrics.
The ProSense detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Save button.
information in the display changes
accordingly.
the programme and to deactivate
the appliance.
activate the appliance.
If the ProSense System has
completed and the water
filling has already started,
the new programme starts
without repeating the
ProSense System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
ENGLISH 31