Table of Contents
Advertisement
SALTDIP™ Pro
PROBLEM
Meter will not turn ON
Salt Reading are
drifting or changing
Specifications / Features
· Operating ranges: 41-122°F (5-50°C), 200-9800ppm (Salt and TDS).
· Temperature sensor: Selectable °C/°F system. Resolution: 0.1°C/.01°F (1°F if >=100°F).
· Automatically saves last recorded reading until new measurement is taken.
· 42x34mm viewing area LCD, Grey background with Black characters, White LED backlight.
· Auto-power off to save batter after 1 minute idle.
Install Batteries
(Requires two AAA batteries)
1. Peel back rubber casing from top of unit and twist off the battery compartment cap.
2. Observe polarity on back of meter and Insert two AAA batteries.
3. Replace the battery compartment cap and make sure it is tightly secured to avoid water intrusion.
4. Battery level indicator will show when low. Replace as necessary.
Toggle °C/°F
· To change the displayed temperature units between °C or °F:With the unit turned ON, press and hold START button
for 4 seconds.
IMPORTANT! CARE AND STORAGE
· Store the SALTDIP™ PRO inside carrying case and keep from extreme temperature.
· Remove metal probe guard and rinse the probe in fresh water after each use to avoid cross contamination
· DO NOT soak the probe in any cleaning solution or chemicals. Doing so may cause degradation in performance.
When cleaning the probe, use fresh water only
This instrument is guaranteed to be free from defects in material and workmanship for a period of
one year from the date of original purchase. The probe is guaranteed to be free from defects in
material and workmanship for a period of six months from the date of original purchase. Damages
brought on by abuse, operator negligence, accident, misapplication, mishandling or acts of God will
void this warranty. This warranty is limited to the repair or replacement of the product at the
discretion of the manufacturer and will not include transportation costs. This product cannot be
returned without a return authorization number from Solaxx. For warranty support or a Return
Authorization number, log onto
support@solaxx.com.
CAUSE
Batteries dead
Wrong Battery Polarity
Salt or Temperature
is out of range
Low Batteries
Probe is dirty
WARRANTY
www.solaxx.com
QUICK START GUIDE
SOLUTION
Replace Batteries
Confirm batteries are installed
properly
Make sure test sample is within
operating ranges.
Salt: 200-9800ppm
Temperature: 41-122°F (5-50°C)
Replace Batteries
Clean Probe with WATER ONLY and a soft sponge.
Check calibration after cleaning using directions on bottle
and click on support or email:
Advertisement
Table of Contents
Need help?
Do you have a question about the SALTDIP Pro and is the answer not in the manual?
Questions and answers