Nortek Control SpeakerCraft HRSi Installation Manual page 6

➓
11
12
XTEQi-12
10. Trigger (XTEQi-12 Only). 12V trigger input turns the amplifier On or Off and
overrides the automatic signal detection circuit, reducing power consumption when
not in use. When this input receives a 12V signal, the subwoofer will turn ON. When the
signal goes away, the subwoofer will turn OFF.
11. Balanced IN (XTEQi-12 only). Balanced connections allow the use of very long
cables while reducing electrical interference. Connect a balanced output cable from your
receiver or preamp to the subwoofers Balanced IN.
12. Balanced OUT (XTEQi-12 only). These connect with Balanced type cables to
daisy-chain additional subwoofers or powered speakers. These outputs are pass-thru,
meaning they will pass through the same audio signal that is fed into the Balanced IN.
SpeakerCraft HRSi / XTEQi
STATUS
TRIGGER
IN
BALANCE
OUT
OPTIONAL WIRELESS RECEIVER
R L/LFE
IN
OUT
LOW LEVEL
220-240V~
ON
OFF
POWER
USB POWER
5V 500mA
100-120V~
6
FUSE T15AL/250V
100-120V~60Hz 12A
220-240V~50Hz 6A